This is a wide curve cant introduction rail with a radius of 354mm, a curve angle of 22.5°, and a width of 37mm. A canted rail where the rail on the outside of the curve is higher than the inside, and the rail is introduced from flat without cant to canted rail gradually.

Features

• Ballast and sleepers are painted for a beautiful appearance
• PC sleepers are expressed
• Rails are joined together with nails for easy and reliable connection
• Connection compatible with conventional TOMIX rails
• Handrails, side walls, and fences (sold separately) can be attached to the side of the rail
• Compatible with single-track piers by attaching the separately sold single-track pier base to the bottom
• Can be used as a double-track rail by connecting CR (L) 391-22.5-WP (sold separately) to the outside
• Wide rail when used as a double-track rail Compatible with double-track elevated piers by attaching a coupling for the cant section (coupling for wide rails and slab rails on the flat lead-in section) to the underside. - Power supply by attaching a feeder for wide rails and slab rails to the underside (feeder for slab rails) . (Can also be installed, conventional feeders cannot be installed)
• Structurally not compatible with sensor installation
• Compatible with various overhead line pole attachments
• Cant inclination angle gradually changes from 0 degrees to approximately 4 degrees with a curve angle of 22.5 degrees
• One set of two each: CR, which gradually cants while curving to the right, and CL, which gradually cants while curving to the left

• Wide PC approach rail CR354-22.5-WP(F)
• Wide PC approach rail CL354-22.5-WP(F)
• Runner parts: Wide rail joint